Shank diameter 3/8"

HSC-T20 DEPO M10

Item number:: 23000207
EAN:: 4007220652756

New

Technical data

PFERD TOOLS worldwide

Technical information

Dia. external: 25/32 Inch
Dia. external: 20 mm
Dia. shank: 5/16 Inch
Dia. shank: 10 mm
Overall length: 1.889 Inch
Overall length: 48 mm
RPM, optimum: 20000 - 30000 RPM
RPM, soft non-ferrous metals: 20000 - 30000 RPM
Suitable for diameter: 10 mm
Packaging unit: 1 piece

Description

The High Speed Torus Cutter is an unparalleled tool for use on robots with an extremely high stock removal rate. Unlike grinding tools, the cutter does not generate hazardous or explosive dust, making it ideal for a variety of applications on aluminum materials. Thanks to its compact design, the High Speed Torus Cutter is the ideal tool for working in hard-to-reach areas and on delicate points such as grooves, pockets and tight radii and contours. The High Speed Torus Cutter is used with two tungsten carbide cutting inserts.

The Cutter perfectly complements the ALUMASTER High Speed Disc in the HSD-R 50 version and burrs with the ALU cut.

Special features

Specially developed design for use in hard-to-reach areas.
Does not generate hazardous or explosive aluminum dust.
Does not require a dust extraction system.
Exceptionally high stock removal rate.
Reduced vibrations due to small contact surface.
Turnable and replaceable tungsten carbide cutting inserts.
Can be used face-down.

Recommendations for use

The ALUMASTER has been designed primarily for use on aluminum, wrought aluminum alloys, and cast aluminum. It can also machine non-ferrous metals that have a relatively low strength, and it can machine fiber-reinforced plastics. Check this for the specific application on a case-by-case basis.
The optimum rotational speed and power output for the tool drive are required for cost-effective use of the Torus Cutter.
The High Speed Torus Cutter can be used on both the circumference and face.

Ordering notes

The cutting inserts are not included.

Safety notes

Tighten the mounting bolts of the cutting inserts using a hexalobular socket wrench TX 15. The tightening torque should be approx. 4 Nm. Alternatively, use a torque spanner with a tightening torque of 4 Nm.
Loose cutting inserts may break during use. Regularly check to make sure they are attached securely.
Do not use damaged cutting inserts, they may break.

Contents

High Speed Torus Cutter including two mounting bolts.

Materials that can be worked: Aluminum; Brass; Bronze; Copper; Fibre-reinforced thermosetting plastics (GRP, CRP); Hard aluminium alloys; Plastics; Soft aluminium alloys; Tough aluminium alloys; Zinc